Videotec WAS Manuel d'utilisateur télécharger pdf (Page 7)

Instructions manual - English - EN

6.1.5 Connecting the pump motor

Operation valid for pump with 30m (98ft)

delivery.

To connect the pump use the auxiliary terminal

present in the waterproof box of the pump (01).

Connect the power supply phase cable (L) and

neutral cable (N).

Connect the earth cable to the pump casing (earth

hole) (02).

Phase (L)Neutral (N)

Fig. 8

Use an external switch (minimum capacity

4A, 250V) to activate the pump.

6.1.6 Pump installation

Be very careful not to start the pump when

the tank is empty.

6.1.6.3 Pump with 5m (16ft) or 11m (36ft)

delivery

Fill the tank with water and insert it in the metal cage.

Insert the pump in the tank and tighten the cap.

The system is ready to be powered.

6.1.6.4 Pump with 30m (98ft) delivery

Adjust the position of the level controller and the

weight.

220mm

120mm

Fig. 9

Fill the tank with water and insert it in the metal

cage, taking care to insert the male/female hydraulic

coupling (01) correctly. Put the oat inside the tank

and screw the plug on. Check the delivery hose

coupling for the pump (02) to make sure a small

quantity of water comes out.

Fig. 10

Connect the supply pipe.

The system is ready to be powered.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Pas de commentaire

Videotec WAS Manuel d'utilisateur Page 7